Home › Vehicle Interior › HEATING / AIR CONDITIONING › REAR AIR CONDITIONING UNIT

REAR AIR CONDITIONING UNIT > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR AIR MIX DAMPER SERVO MOTOR SUB-ASSEMBLY


    I104307
  1. Disconnect the connector.

  1. Remove the 2 screws and rear air mix control servo motor.



2. REMOVE REAR MODE DAMPER SERVO MOTOR SUB-ASSEMBLY


    E191234
  1. Remove the 4 screws and the bracket.



    I104310
  1. Disconnect the connector.

  1. Remove the 2 screws and rear mode damper servo motor.



3. REMOVE AIRCONDITIONER CONNECTOR TUBE


    I104312
  1. Remove the packing.



    I104313
  1. Disconnect the hose.

  1. Remove the 3 screws.



    I104314
  1. Remove the bolt and side the hook connector.

  1. Remove the air conditioning connector tube.



    I104316
  1. Remove the 2 O-rings from the air conditioning connector tube.



4. REMOVE WATER PIPE SUB-ASSEMBLY


    I104317
  1. Remove the 4 screws and the bracket.



    E183739
  1. Using pliers, grip the claws of the 2 clips and side the clips to remove the water pipe.



5. REMOVE HEATER WATER INLET HOSE


    E183887
  1. Using pliers, grip the claws of the clip and slide the clips to disconnect the heater water hose.



6. REMOVE HEATER WATER OUTLET HOSE


    E183888
  1. Using pliers, grip the claws of the clip and slide the clips to disconnect the heater water hose.



7. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY


    E183889
  1. Remove the screw.

  1. Detach the claw and remove the heater clamp.



    E183890
  1. Remove the heater radiator unit from the rear cooling unit as shown in the illustration.



8. REMOVE REAR BLOWER MOTOR SUB-ASSEMBLY


    I104324
  1. Remove the 3 screws and the rear blower motor.



9. REMOVE BLOWER MOTOR CONTROL


    I104325
  1. Remove the 2 screws and the blower motor controller.



10. REMOVE REAR COOLING UNIT EXPANSION VALVE


    I104326
  1. Detach the 3 claws and remove the plate.



    I104327
  1. Remove the grommet.



    E150105
  1. Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and rear cooling unit expansion valve.



11. REMOVE REAR EVAPORATOR TEMPERATURE SENSOR


    I104328
  1. Detach the clamp.

  1. Detach the claw and the rear evaporator temperature sensor.



12. REMOVE REAR EVAPORATOR SUB-ASSEMBLY


    I104329
  1. Remove the 13 screws.



    I104330
  1. Remove the rear evaporator as shown in the illustration.



    E150109
  1. Remove the 2 O-rings from the rear evaporator.