Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR SYSTEM

DTC    B2222    PBD Pulse Sensor Malfunction

for Preparation Click here


DESCRIPTION

  1. A pulse sensor is built into the power back door drive unit to detect foreign objects and the back door position. The pulse sensor monitors the operating speed of the back door to detect foreign objects. The pulse sensor also monitors where the back door is to detect the back door position. If a pulse signal that is out of the normal range is output, the power back door drive unit (power back door ECU) will store DTC B2222.
  2. If DTC B2222 is stored, the power back door system will be turned off and the back door will be switched to manual operation mode (not electrically controlled).
  3. In order to restore the power back door system to normal operation mode, first solve the problem indicated by DTC B2222 and then fully close the back door manually (reset operation).

    DTC No.
    DTC Detection Condition
    Trouble Area
    B2222
    Power back door drive unit does not operate
    Power back door drive unit (Power back door ECU)

INSPECTION PROCEDURE

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2222 is not output.



NG
REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)