Home › Engine / Hybrid System ยท 1UR-FE › COOLING › RADIATOR

RADIATOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT BUMPER COVER
  1. Remove the front bumper cover (Click here).



2. REMOVE NO.1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



3. REMOVE ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap. Then drain the coolant from the radiator.

  1. Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.



  1. Tighten the 2 cylinder block drain cock plugs.


    A215892E01

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. Tighten the radiator drain cock plug by hand.



4. REMOVE V-BANK COVER SUB-ASSEMBLY


    A214822E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



5. REMOVE AIR CLEANER ASSEMBLY


    A215422
  1. Disconnect the MAF meter connector and clamp.

  1. Disconnect the ventilation hose and vacuum hose.

  1. Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner.



6. REMOVE INLET RADIATOR HOSE


    A215577
  1. Remove the radiator hose.



7. REMOVE FAN SHROUD


    A217580
  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the fan generator V-belt (Click here).

  1. Disconnect the reservoir hose from the upper radiator tank.



    A151821
  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the fluid coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the fan bracket.



8. DISCONNECT OUTLET RADIATOR HOSE


    A215882
  1. Disconnect the radiator hose.



9. REMOVE RADIATOR SIDE DEFLECTOR RH


    A215585
  1. Using a clip remover, remove the 6 clips and side deflector.



10. REMOVE RADIATOR SIDE DEFLECTOR LH


    A215586
  1. Using a clip remover, remove the 6 clips and side deflector.

  1. Disconnect the wire harness clamp.



11. REMOVE NO. 1 RADIATOR TO SUPPORT SEAL (for LH Side)


    A183237
  1. Remove the 3 clips and remove the No. 1 radiator to support seal.



12. REMOVE NO. 1 RADIATOR TO SUPPORT SEAL (for RH Side)


    A183236
  1. Remove the 3 clips and remove the No. 1 radiator to support seal.



13. REMOVE RADIATOR ASSEMBLY


    A183239
  1. Remove the 4 bolts and radiator.



    A183240
  1. Remove the radiator hose from the radiator.

  1. Remove the drain cock plug.

  1. Remove the O-ring.