INTUITIVE PARKING ASSIST SYSTEM > Park / Neutral Position Switch Circuit |

| 1.INSPECT PARK / NEUTRAL POSITION SWITCH |
![]() |
Disconnect the D21 park/neutral position switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Condition | Specified Condition |
| 6 (PL) - 2 (RB) | Shift lever in P | Below 1 Ω |
| 1 (RL) - 2 (RB) | Shift lever in R | Below 1 Ω |
| 6 (PL) - 2 (RB) | Shift lever not in P | 10 kΩ or higher |
| 1 (RL) - 2 (RB) | Shift lever not in R | 10 kΩ or higher |
| Result | Proceed to |
| OK | A |
| NG (for A760E) | B |
| NG (for A760F) | C |
| NG (for AB60E) | D |
| NG (for AB60F) | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (SWITCH - CLEARANCE WARNING ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the D21 park/neutral position switch connector.
Disconnect the H43 clearance warning ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Condition | Switch Condition | Specified Condition |
| D21-2 (RB) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Condition | Specified Condition |
| D21-6 (PL) - H43-1 (PL) | Always | Below 1 Ω |
| D21-1 (RL) - H43-13 (RL) | ||
| D21-6 (PL) - Body ground | Always | 10 kΩ or higher |
| D21-1 (RL) - Body ground |
|
| ||||
| OK | ||
| ||