Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Rear Clearance Sonar Sensor RH Circuit

for Preparation Click here


DESCRIPTION

The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance value between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU.

WIRING DIAGRAM


E132019E18


INSPECTION PROCEDURE

1.REPLACE REAR CORNER NO. 1 ULTRASONIC SENSOR RH
  1. Replace the rear corner No. 1 ultrasonic sensor with a normally functioning sensor (Click here).


NEXT


2.CHECK HARNESS AND CONNECTOR (REAR CORNER SENSOR RH - CLEARANCE WARNING ECU)


    B144573E17
  1. Disconnect the R2 rear corner No. 1 ultrasonic sensor connector.

  1. Disconnect the H43 clearance warning ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R2-1 (BI) - H43-24 (BOR)
    Always
    Below 1 Ω
    R2-3 (SI) - H43-6 (SOR)
    R2-5 (EI) - H43-22 (E2)
    R2-1 (BI) - Body ground
    Always
    10 kΩ or higher
    R2-3 (SI) - Body ground
    R2-5 (EI) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)