REAR CRANKSHAFT OIL SEAL > REMOVAL |
| 1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY |
Remove the automatic transmission assembly (Click here).
| 2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
![]() |
Using SST, hold the crankshaft.
![]() |
Remove the 10 bolts, rear drive plate spacer, drive plate and crankshaft angle sensor rotor.
| 3. REMOVE ENGINE REAR OIL SEAL |
Using a knife, cut off the lip of the oil seal.
![]() |
Using a screwdriver, pry out the oil seal.