Home › Engine / Hybrid System ยท 3UR-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for 2WD)
  1. Remove the automatic transmission assembly (Click here).



2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for 4WD)
  1. Remove the automatic transmission assembly (Click here).



3. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    A163778E01
  1. Using SST, hold the crankshaft.

    SST
    09213-70011  
    09330-00021  



    A163779
  1. Remove the 10 bolts, rear drive plate spacer, drive plate and crankshaft angle sensor rotor.



4. REMOVE ENGINE REAR OIL SEAL
  1. Using a knife, cut off the lip of the oil seal.



    A163776E01
  1. Using a screwdriver, pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole and crankshaft.