Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Cellular Phone Voice Circuit between Radio Receiver and Stereo Component Amplifier

for Preparation Click here


SYSTEM DESCRIPTION

This circuit is used when the cellular phone voice in the "Bluetooth" handsfree system is on.

WIRING DIAGRAM


E190625E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER)


    E145926E02
  1. Disconnect the I3 radio receiver assembly connector.

  1. Disconnect the I17 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I3-11 (IVO+) - I17-15 (Il1+)
    Always
    Below 1 Ω
    I3-12 (IVO-) - I17-14 (Il1-)
    Always
    Below 1 Ω
    I3-11 (IVO+) - Body ground
    Always
    10 kΩ or higher
    I3-12 (IVO-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)