Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR CONTROL SWITCH (for Luggage Compartment)

POWER BACK DOOR CONTROL SWITCH (for Luggage Compartment) > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR CONTROL SWITCH


B192520E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (E) - 8 (DS1)
    Pushed
    Below 1 Ω
    5 (E) - 8 (DS1)
    Free
    10 kΩ or higher

    If the result is not as specified, replace the switch.



    B194507E02
  1. Check the illumination operation.

    1. Connect the positive (+) battery lead to terminal 7 (ILL+) and the negative (-) battery lead to terminal 6 (ILL-), then check that the illumination illuminates.

      OK:
      Illumination illuminates.

      If the illumination does not illuminate, replace the back door control switch.