Home › Engine / Hybrid System ยท 3UR-FE › ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH

POWER STEERING OIL PRESSURE SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL POWER STEERING OIL PRESSURE SWITCH
  1. Install a new O-ring to the oil pressure switch.

  1. Apply a light coat of engine oil to the O-ring of the oil pressure switch.

    NOTICE:
    1. When reusing the oil pressure switch, inspect the O-ring.
    2. If the O-ring has scratches or cuts, replace the new O-ring.



    A186999
  1. Using a 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    21 N*m{ 214 kgf*cm , 16 ft.*lbf }

  1. Connect the oil pressure switch connector.



2. ADD POWER STEERING FLUID


3. BLEED POWER STEERING FLUID
  1. Check the fluid level.

  1. Jack up the front of the vehicle and support it with stands.

  1. Turn the steering wheel.

    1. With the engine stopped, turn the wheel slowly from lock to lock several times.

  1. Lower the vehicle.

  1. Start the engine.

  1. Run the engine at idle for a few minutes.

  1. Turn the steering wheel.

    1. With the engine idling, turn the wheel left or right to the full lock position and keep it there for 2 to 3 seconds, then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds.(*1)

    2. Repeat (*1) several times.

  1. Stop the engine.



    C124274E04
  1. Check for foaming or emulsification.
    Text in Illustration 
    *a
    Correct
    *b
    Incorrect
    If the system has to be bled twice because of foaming or emulsification, check for fluid leaks in the system.

  1. Check the fluid level.



4. INSPECT FOR POWER STEERING FLUID LEAK


5. INSTALL FRONT FENDER APRON SEAL RH
  1. Install the fender apron seal with the 6 clips.