Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1UR-FE)

VANE PUMP (for 1UR-FE) > INSTALLATION

for Preparation Click here



1. INSTALL VANE PUMP ASSEMBLY


A163333E01

HINT:
Before performing the following procedures, move the spacer until the vane pump cam be installed.



    C181328
  1. Install the vane pump with the 2 bolts.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }



2. CONNECT PRESSURE FEED TUBE


C181327
  1. Install a new gasket to the pressure feed tube.

  1. Install the pressure feed tube with the union bolt.

    Torque:
    51 N*m{ 520 kgf*cm , 38 ft.*lbf }



3. CONNECT SOLENOID VALVE CONNECTOR


C181333
  1. Connect the solenoid valve connector.



4. CONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR


C181326
  1. Connect the oil pressure sensor connector.



5. CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE


C181325E01
  1. Connect the hose with the clip.



6. CONNECT HARNESS BRACKET


C181324
  1. Install the bracket with the bolt.



7. INSTALL RADIATOR ASSEMBLY
  1. Install the radiator assembly (Click here).



8. ADD POWER STEERING FLUID


9. BLEED POWER STEERING FLUID
  1. Check the fluid level.

  1. Jack up the front of the vehicle and support it with stands.

  1. Turn the steering wheel.

    1. With the engine stopped, turn the wheel slowly from lock to lock several times.

  1. Lower the vehicle.

  1. Start the engine.

  1. Run the engine at idle for a few minutes.

  1. Turn the steering wheel.

    1. With the engine idling, turn the wheel left or right to the full lock position and keep it there for 2 to 3 seconds, then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds.(*1)

    2. Repeat (*1) several times.

  1. Stop the engine.



    C124274E04
  1. Check for foaming or emulsification.
    Text in Illustration 
    *a
    Correct
    *b
    Incorrect
    If the system has to be bled twice because of foaming or emulsification, check for fluid leaks in the system.

  1. Check the fluid level.



10. INSPECT FOR POWER STEERING FLUID LEAK