Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 3UR-FE, 3UR-FBE)

VANE PUMP (for 3UR-FE, 3UR-FBE) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
  1. After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected .



3. REMOVE V-BANK COVER SUB-ASSEMBLY


A165576E03
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



4. REMOVE AIR CLEANER ASSEMBLY


    A183242
  1. Loosen the hose clamp and disconnect the air cleaner from the air cleaner hose.

  1. Loosen the 2 bolts and remove the air cleaner with the grommet.



5. REMOVE FAN AND GENERATOR V BELT


    A163770E01
  1. While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of φ 5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.

    HINT:
    The pulley bolt for the belt tensioner has a left-hand thread.

  1. Remove the fan and generator V belt.



6. DRAIN POWER STEERING FLUID


7. DISCONNECT WIRE HARNESS CLAMP


C161008
  1. Disconnect the wire harness clamp.



8. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE


C161009E01
  1. Disconnect the No. 1 oil reservoir to pump hose.



9. DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR


C161010
  1. Disconnect the power steering oil pressure sensor connector.



10. DISCONNECT PRESSURE FEED TUBE


    C161011E01
  1. Remove the bolt and disconnect the pressure feed tube.

  1. Remove the gasket.



11. REMOVE VANE PUMP ASSEMBLY


C161012
  1. Remove the 2 bolts and vane pump.