STEERING GEAR > DISASSEMBLY |
| 1. FIX POWER STEERING GEAR ASSEMBLY |
![]() |
Using SST, secure the power steering gear.
| 2. REMOVE TIE ROD END SUB-ASSEMBLY LH |
![]() |
Put matchmarks on the tie rod end LH and steering rack end.
| 3. REMOVE TIE ROD END SUB-ASSEMBLY RH |
| 4. REMOVE STEERING RACK BOOT CLIP |
Using pliers, remove the 2 steering rack boot clips.
| 5. REMOVE NO. 2 STEERING RACK BOOT CLAMP |
![]() |
Using pliers, remove the 2 boot clamps as shown in the illustration.
| 6. REMOVE NO. 2 STEERING RACK BOOT |
| 7. REMOVE NO. 1 STEERING RACK BOOT |
| 8. REMOVE STEERING RACK END SUB-ASSEMBLY |
![]() |
Using a screwdriver and hammer, stake back the washer.
Using a wrench, hold the steering rack (LH side).
![]() |
Using SST, remove the steering rack end (LH side) from the power steering rack.
Using SST, remove the steering rack end (RH side) from the power steering rack.
Remove the 2 claw washers.
| 9. REMOVE STEERING GEAR RACK GUIDE |
![]() |
Using SST, remove the steering rack guide spring cap nut.
![]() |
Using a 32 mm hexagon wrench, remove the rack guide spring cap.
Remove the spring and rack guide.
| 10. REMOVE POWER STEERING CONTROL VALVE |
![]() |
Wind vinyl tape around the serrated portion of the control valve.
Remove the dust cover from the control valve housing.
![]() |
Remove the 2 bolts.
Pull out the control valve from the rack housing.
Remove the control valve oil seal.
![]() |
To prevent the oil seal lip from getting damaged, wind vinyl tape around the serrated portion of the control valve.
Using a plastic hammer, remove the control valve from the control valve housing.
![]() |
Using a screwdriver, remove the 4 control valve rings.
| 11. REMOVE POWER STEERING CONTROL VALVE UPPER OIL SEAL |
![]() |
Using SST and a press, remove the control valve upper bearing and control valve upper oil seal from the control valve housing.
| 12. REMOVE CYLINDER END STOPPER |
![]() |
Using a screwdriver and hammer, turn the cylinder end stopper clockwise until the wire end can be seen through the service hole.
Using a screwdriver and hammer, turn the cylinder end stopper counterclockwise, and remove the wire and cylinder end stopper.
| 13. REMOVE POWER STEERING RACK |
| 14. REMOVE POWER STEERING RACK BUSH |
Remove the rack bush from the power steering rack.
Using a screwdriver, remove the O-ring from the rack bush.
![]() |
Using SST, remove the rack bush oil seal.
| 15. REMOVE POWER STEERING CYLINDER TUBE OIL SEAL |
![]() |
Using SST and a press, remove the cylinder tube oil seal.
| 16. REMOVE RACK STEERING PISTON RING |
![]() |
Using a screwdriver, remove the piston ring and O-ring.