Home › Engine / Hybrid System ยท 3UR-FE › FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
  1. Apply a light coat of gasoline or spindle oil to a new O-ring, and install it to the fuel pressure regulator.

    NOTICE:
    1. Make sure that there are no scratches or foreign matter in or around the insertion hole of the delivery pipe.
    2. When inserting the fuel pressure regulator, be careful not to damage the O-ring.



    A161402E01
  1. While turning the pressure regulator left and right, install it to the fuel delivery pipe.



    A161401
  1. Install the 2 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



    A161400
  1. Connect the vacuum sensing hose to the pressure regulator.



2. INSTALL NO. 2 FUEL TUBE SUB-ASSEMBLY
  1. Connect the No. 2 fuel tube to the fuel pressure regulator (for quick type) (Click here).



3. INSTALL AIR CLEANER HOSE ASSEMBLY


A187008
  1. Install the air cleaner hose with the 2 clamps.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }

  1. Connect the vacuum hose.

  1. Connect the ventilation hose.



4. INSPECT FOR FUEL LEAK
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON and Techstream on.

    NOTICE:
    Do not start the engine.

  1. Techstream:
    Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

  1. Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.



5. INSTALL V-BANK COVER


A165576E03
  1. Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins, and press down on the V-bank cover to attach the pins.