EXHAUST PIPE > REMOVAL |
| 1. REMOVE TAILPIPE ASSEMBLY |
![]() |
Remove the bolt, clamp and gasket.
Disconnect the tailpipe assembly from the exhaust pipe support.
| 2. REMOVE CENTER EXHAUST PIPE ASSEMBLY |
![]() |
Remove the 4 bolts.
Disconnect the center exhaust pipe assembly from the 3 exhaust pipe supports.
Remove the center exhaust pipe assembly from the front exhaust pipe assembly and front No. 3 exhaust pipe sub-assembly.
Remove the 2 gaskets from the front exhaust pipe assembly and front No. 3 exhaust pipe sub-assembly.
| 3. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) |
![]() |
Disconnect the heated oxygen sensor connector.
Using SST, remove the heated oxygen sensor.
| 4. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) |
![]() |
Disconnect the heated oxygen sensor connector and 2 clamps..
Using SST, remove the heated oxygen sensor.
| 5. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY |
![]() |
Remove the 2 bolts and 2 nuts.
Disconnect the front No. 3 exhaust pipe sub-assembly from the exhaust pipe support.
Remove the front No. 3 exhaust pipe sub-assembly from the front No. 2 exhaust pipe sub-assembly assembly.
Disconnect the air fuel ratio sensor connector.
![]() |
Remove the 3 nuts, front No. 2 exhaust pipe sub-assembly and 2 gaskets from the exhaust manifold LH.
| 6. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Disconnect the air fuel ratio sensor connector.
![]() |
Remove the 3 nuts, front exhaust pipe and gasket from the exhaust manifold RH.
| 7. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
![]() |
Using SST, remove the air fuel ratio sensor.
| 8. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
![]() |
Using SST, remove the air fuel ratio sensor.
| 9. REMOVE MONOLITHIC CONVERTER PROTECTOR (for Bank 1) |
![]() |
Remove the 4 bolts and 4 nuts.
Remove the 2 monolithic converter protectors.
Remove the 2 LH converter protector stays and 2 No. 2 converter protector stays.
| 10. REMOVE NO. 1 MONOLITHIC CONVERTER PROTECTOR (for Bank 1) |
![]() |
Remove the 4 bolts and 4 nuts.
Remove the 2 No. 1 monolithic converter protectors.
Remove the 2 No. 2 converter protector stay and 2 No. 3 converter protector stay.
| 11. REMOVE MONOLITHIC CONVERTER PROTECTOR (for Bank 2) |
![]() |
Remove the 4 bolts and 4 nuts.
Remove the 2 monolithic converter protectors.
Remove the 2 LH converter protector stays and 2 No. 2 converter protector stays.
| 12. REMOVE NO. 1 MONOLITHIC CONVERTER PROTECTOR (for Bank 2) |
![]() |
Remove the 4 bolts and 4 nuts.
Remove the 2 No. 1 monolithic converter protectors.
Remove the 2 No. 2 converter protector stays and 2 No. 3 converter protector stays.