EXHAUST PIPE > REMOVAL |
| 1. REMOVE TAILPIPE ASSEMBLY |
![]() |
Remove the bolt, clamp and gasket.
Disconnect the tailpipe from the exhaust pipe support.
| 2. REMOVE CENTER EXHAUST PIPE ASSEMBLY |
![]() |
Remove the 4 bolts.
Disconnect the center exhaust pipe from the 3 exhaust pipe supports.
Remove the center exhaust pipe from the front exhaust pipe and front No. 2 exhaust pipe.
Remove the 2 gaskets from the front exhaust pipes.
| 3. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD) |
![]() |
Remove the 2 bolts and heat insulator from the heat insulator bracket.
| 4. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) |
Disconnect the sensor connector.
![]() |
Using SST, remove the sensor.
| 5. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY |
![]() |
Remove the 2 bolts and 2 nuts.
Disconnect the front No. 3 exhaust pipe from the exhaust pipe support.
Remove the front No. 3 exhaust pipe from the front No. 2 exhaust pipe.
Disconnect the air fuel ratio sensor connector.
![]() |
Remove the 3 nuts, front No. 2 exhaust pipe and 2 gaskets from the exhaust manifold LH.
| 6. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) |
![]() |
Disconnect the heated oxygen sensor connector and 2 clamps.
Using SST, remove the sensor.
| 7. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
![]() |
Disconnect the air fuel ratio sensor connector.
Remove the 3 nuts, front exhaust pipe and gasket from the exhaust manifold RH
| 8. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
![]() |
Using SST, remove the sensor.
| 9. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
![]() |
Using SST, remove the sensor.
| 10. REMOVE MONOLITHIC CONVERTER PROTECTOR (for Bank 1) |
![]() |
Remove the 4 bolts, 4 nuts, lower monolithic converter protector, upper monolithic converter protector, 2 No. 1 converter protector stays and 2 No. 2 converter protector stays.
| 11. REMOVE NO. 1 MONOLITHIC CONVERTER PROTECTOR (for Bank 1) |
![]() |
Remove the 4 bolts, 4 nuts, lower No. 1 monolithic converter protector, upper No. 1 monolithic converter protector and 4 No. 1 converter protector stays.
| 12. REMOVE MONOLITHIC CONVERTER PROTECTOR (for Bank 2) |
![]() |
Remove the 4 bolts, 4 nuts, lower monolithic converter protector, upper monolithic converter protector, 2 No. 1 converter protector stays and 2 No. 2 converter protector stays.
| 13. REMOVE NO. 1 MONOLITHIC CONVERTER PROTECTOR (for Bank 2) |
![]() |
Remove the 4 bolts, 4 nuts, lower No. 1 monolithic converter protector, upper No. 1 monolithic converter protector and 4 No. 1 converter protector stays.