PROPELLER SHAFT ASSEMBLY (for 4WD) > REASSEMBLY |
| 1. INSTALL REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER |
![]() |
Apply MP grease to a new universal joint spider and universal joint spider bearings.
![]() |
Measure dimension A between the snap ring grooves.
Install the universal joint spider bearing into the universal joint spider and measure dimension B.
Select hole snap rings of the correct thickness to make dimensions A and B the same.
![]() |
w/o Grease Fitting Spider Bearing:
| Color | Thickness |
| Purple | 1.46 mm (0.0574 in.) |
| Black | 1.49 mm (0.0586 in.) |
| Copper | 1.51 mm (0.0594 in.) |
| Black | 1.52 mm (0.0598 in.) |
| Black | 1.54 mm (0.0606 in.) |
| White | 1.56 mm (0.0614 in.) |
| Black | 1.57 mm (0.0618 in.) |
| Yellow | 1.59 mm (0.0625 in.) |
| Black | 1.62 mm (0.0638 in.) |
| Blue | 1.64 mm (0.0646 in.) |
![]() |
w/ Grease Fitting Spider Bearing:
| Color | Thickness |
| Black | 1.49 mm (0.0586 in.) |
| Copper | 1.51 mm (0.0594 in.) |
| White | 1.56 mm (0.0614 in.) |
| Yellow | 1.59 mm (0.0625 in.) |
Temporarily install the universal joint spider and 2 universal joint spider bearings into the universal joint sleeve yoke.
![]() |
Using SST, press the universal joint spider bearing into the universal joint sleeve yoke until the groove can be seen.
![]() |
Using needle-nose pliers, install a hole snap ring into the groove on the universal joint sleeve yoke.
Temporarily install the universal joint spider and 2 universal joint spider bearings into the propeller shaft's universal joint yoke.
![]() |
Using SST, press the universal joint spider bearing into the universal joint yoke until the groove can be seen.
![]() |
Using needle-nose pliers, install a hole snap ring into the groove on the universal joint yoke.
| 2. INSPECT PROPELLER SHAFT GREASE FITTING DIRECTION |

| 3. INSPECT UNIVERSAL JOINT SPIDER BEARING |
![]() |
Mount the propeller shaft in a vise.
Inspect the spider bearing for wear or damage.
Using a dial indicator, measure the spider bearing axial play by turning the yoke of the flange while holding the shaft tightly.