Home › Engine / Hybrid System ยท 3UR-FBE › EMISSION CONTROL › CANISTER

CANISTER > REMOVAL

for Preparation Click here



1. DISCONNECT FUEL TANK VENT HOSE SUB-ASSEMBLY


A184908
  1. Pull up the retainer and disconnect the vent line hose.

    NOTICE:
    1. Do not use any tools in this procedure.
    2. Check for any dirt and foreign matter contamination in the valve and around the connector. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the valve and connector.

  1. Remove the bolt.



2. DISCONNECT NO. 1 CHARCOAL CANISTER OUTLET HOSE


A184911
  1. Disconnect the No. 1 charcoal canister outlet hose.



3. REMOVE CHARCOAL CANISTER ASSEMBLY


A184910
  1. Disconnect the charcoal canister outlet hose.



    A184912
  1. Disconnect the connector.



    A184913
  1. Remove the 3 bolts and charcoal canister assembly.



4. REMOVE FUEL TANK VENT HOSE SUB-ASSEMBLY


A184914E01
  1. Push the hose firmly toward the canister side.

  1. Pinch the hose (portion A) as shown in the illustration.

  1. Pull out the hose.

    NOTICE:
    1. Do not use any tools in this procedure.
    2. Check for any dirt and foreign matter contamination in the canister and around the hose. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the canister and hose.



5. REMOVE CHARCOAL CANISTER BASE BRACKET


A184915E01
  1. Disconnect the No. 2 canister outlet hose sub-assembly.

    1. Push the hose firmly toward the canister side.

    2. Pinch the hose (portion A) as shown in the illustration.

    3. Pull out the hose.

      NOTICE:
      1. Do not use any tools in this procedure.
      2. Check for any dirt and foreign matter contamination in the canister and around the hose. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the canister and hose.

  1. Remove the charcoal canister filter sub-assembly.

  1. Disconnect the charcoal canister outlet hose from hose clamp.



    A184917
  1. Remove the hose clamp.



    A184918
  1. Remove the 2 bolts and charcoal canister base bracket.



6. REMOVE CHARCOAL CANISTER SUPPORT BRACKET


A184920
  1. Remove the 2 bolts and charcoal canister support bracket.



7. REMOVE NO. 1 CHARCOAL CANISTER OUTLET HOSE


A184916
  1. Remove the No. 1 charcoal canister outlet hose.



8. REMOVE CHARCOAL CANISTER OUTLET HOSE


A184919
  1. Remove the charcoal canister outlet hose.



9. REMOVE CHARCOAL CANISTER LEAK DETECTION PUMP SUB-ASSEMBLY
  1. Before removing the charcoal canister leak detection pump, clean the canister by blowing air into it to ensure that the canister is free of foreign matter.

    NOTICE:
    1. Make sure to clean the canister using only air.
    2. Do not use gasoline, thinners or solvents.



    A259574
  1. Disconnect the vacuum hose.

  1. Remove the 3 bolts and charcoal canister leak detection pump.



  1. Check if the canister contains foreign matter such as mud or water.



      A259576
    1. Visually check that the inside of the canister is free of foreign matter.

    2. Hold the canister upside down to make sure that the canister is free of foreign matter.
      If the canister contains foreign matter, replace the canister.