DYNAMIC LASER CRUISE CONTROL SYSTEM > Washer Signal Circuit |

| 1.CHECK WASHER SYSTEM |
Check that the front washer operates.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - WINDSHIELD WIPER SWITCH) |
![]() |
Disconnect the A43 distance control ECU connector and H14 windshield wiper switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A43-3 (WASH) - H14-3 (WF) | Always | Below 1 Ω |
| H14-3 (WF) - Body ground | Always | 10 kΩ or higher |
Reconnect the distance control ECU connector and windshield wiper switch connector.
|
| ||||
| OK | ||
| ||