WIPER SWITCH > REMOVAL |
| 1. REMOVE FRONT DOOR SCUFF PLATE LH |
| 2. REMOVE COWL SIDE TRIM BOARD LH |
| 3. REMOVE INSTRUMENT SIDE PANEL LH |
![]() |
Using a moulding remover, detach the 7 claws and remove the side panel.
| 4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Remove the 2 bolts.
Detach the 9 clips and claw.
![]() |
Detach the 2 claws and remove the sensor.
Remove the finish panel and then disconnect the connectors.
| 5. REMOVE LOWER STEERING COLUMN COVER (for Power Tilt and Power Telescopic Steering Column) |
Turn the ignition switch to ON. Operate the tilt and telescopic switch to fully extend and lower the steering column.
![]() |
While turning the steering wheel to the right and left, remove the 2 screws and the lower steering column cover.
Disengage the 2 claws to remove the lower steering column cover.
| 6. REMOVE LOWER STEERING COLUMN COVER (for Manual Tilt and Manual Telescopic Steering Column) |
Operate the tilt and telescopic lever to fully extend and lower the steering column.
![]() |
While turning the steering wheel to the right and left, remove the 2 screws and the lower steering column cover.
Disengage the 2 claws to remove the lower steering column cover.
| 7. REMOVE UPPER STEERING COLUMN COVER |
![]() |
Disengage the 4 clips.
Disengage the claw to remove the upper steering column cover.
| 8. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY |
![]() |
Disconnect the 2 connectors.
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the wiper switch.