Home › Engine / Hybrid System ยท 1UR-FE › STARTING › STARTER (for 2.0 kW Type)

STARTER (for 2.0 kW Type) > REASSEMBLY

for Preparation Click here



1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY


    A258318E01
  1. Apply high-temperature grease to the areas of the starter pinion drive lever indicated in the illustration.

  1. Install the starter pinion drive lever and rubber seal to the starter center bearing clutch.

  1. Install the starter center bearing clutch together with the starter pinion drive lever and rubber seal to the starter drive housing.



    A258319E01
  1. Apply high-temperature grease to the planetary gears and pins of the starter center bearing clutch as shown in the illustration.

  1. Install the 3 planetary gears.



2. INSTALL STARTER ARMATURE ASSEMBLY
  1. Install the starter armature to the starter yoke.

    NOTICE:
    The magnet of the starter yoke may attract the starter armature when the starter commutator end frame is installed, causing the magnet to break.



3. INSTALL STARTER BRUSH HOLDER ASSEMBLY


    A215977
  1. Push out the 4 brushes from the brush holder so that they are held in place by the springs as shown in the illustration.



    A215968
  1. Install the brush holder to the starter armature and push in the 4 brushes.

    NOTICE:
    Check that the positive (+) lead wires are not grounded.



    A187223E10
  1. Insert the grommet between the positive side and negative side.



4. INSTALL STARTER YOKE ASSEMBLY


    A258320E01
  1. Install the starter armature plate to the starter yoke.

    NOTICE:
    Install the starter armature plate so that the keyway is positioned between key A and key B.

  1. Install the starter commutator end frame with the 2 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }



    A258321E01
  1. Align the key of the starter yoke with the keyway located on the starter drive housing.

  1. Using a T25 "TORX" socket wrench, install the 2 bolts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



5. INSTALL MAGNET STARTER SWITCH ASSEMBLY


    A258322E01
  1. Apply high-temperature grease to the plunger hook.

  1. Hang the plunger of the magnet starter switch onto the drive lever from the upper side.

  1. Install the magnet starter switch with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the lead wire to the magnet starter switch with the nut.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }