Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RESET SWITCH

TIRE PRESSURE WARNING RESET SWITCH > INSPECTION

for Preparation Click here



1. INSPECT TIRE PRESSURE WARNING RESET SWITCH


    C162893E02
  1. Measure the resistance between terminals 1 and 2 of the tire pressure warning reset switch when the tire pressure warning switch is ON and OFF.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    ON
    Below 1 Ω
    OFF
    10 kΩ or higher

    If the result is not as specified, replace the tire pressure warning reset switch.