Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > Navigation Receiver Assembly Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source circuit to operate the navigation receiver assembly.

WIRING DIAGRAM


E138083E04


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - BATTERY AND BODY GROUND)


    E168560E17
  1. Disconnect the I20 navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below .

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    I20-20 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I20-1 (B) - I20-20 (GND)
    Always
    11 to 14 V
    I20-11 (ACC) - I20-20 (GND)
    Ignition switch ACC
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)