CYLINDER HEAD > DISASSEMBLY |
| 1. REMOVE INTAKE VALVE |
![]() |
Using SST and wooden blocks, compress the compression spring and remove the valve spring retainer locks.
Remove the retainer, compression spring and valve.
| 2. REMOVE EXHAUST VALVE |
![]() |
Using SST and wooden blocks, compress the compression spring and remove the valve spring retainer locks.
Remove the retainer, compression spring and valve.
| 3. REMOVE VALVE STEM OIL SEAL |
![]() |
Using needle-nose pliers, remove the oil seals.
| 4. REMOVE VALVE SPRING SEAT |
![]() |
Using compressed air and a magnetic finger, remove the valve spring seat by blowing air onto it.
| 5. REMOVE NO. 1 STRAIGHT SCREW PLUG |
![]() |
Using a 10 mm hexagon wrench, remove the 6 screw plugs and 6 gaskets.
| 6. REMOVE NO. 2 STRAIGHT SCREW PLUG |
![]() |
Using a 14 mm hexagon wrench, remove the 2 screw plugs and 2 gaskets.
| 7. REMOVE STUD BOLT |