Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE HUB

REAR AXLE HUB > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE PARKING BRAKE ASSEMBLY
(Click here)


2. INSPECT REAR AXLE HUB BEARING LOOSENESS


    C181038
  1. Using a dial indicator, check for looseness near the center of the axle hub.

    Maximum:
    0.05 mm (0.00197 in.)

    NOTICE:
    Ensure that the dial indicator is set at a right angle to the measurement surface.

    If the looseness exceeds the maximum, replace the axle hub.



3. INSPECT REAR AXLE HUB RUNOUT


    C181039
  1. Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

    Maximum:
    0.05 mm (0.0020 in.)

    NOTICE:
    Ensure that the dial indicator is set at a right angle to the measurement surface.

    If the runout exceeds the maximum, replace the axle hub.



4. INSTALL PARKING BRAKE ASSEMBLY
(Click here)