WIPER AND WASHER SYSTEM > Headlight Cleaner Motor and Relay Circuit |

| 1.INSPECT FUSE (ECU-IG No. 2, H-LP CLN) |
![]() |
Remove the ECU-IG No. 2 fuse from the main body ECU.
Remove the H-LP CLN fuse from the engine junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ECU-IG No. 2 fuse | Always | Below 1 Ω |
| H-LP CLN fuse |
Reinstall the ECU-IG No. 2 fuse.
Reinstall the H-LP CLN fuse.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER CONTROL RELAY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the A32 headlight cleaner control relay connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A32-3 (IG) - Body ground | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A32-4 (E) - Body ground | Always | Below 1 Ω |
Reconnect the headlight cleaner control relay connector.
|
| ||||
| OK | |
| 3.INSPECT HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY |
![]() |
Remove the A30 headlight cleaner motor and pump assembly.
Connect the battery positive (+) lead to terminal 1 and the negative (-) lead to terminal 2.
Check that the rear washer motor operates.
Remove the headlight cleaner motor and pump assembly.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (CLEANER MOTOR - HEADLIGHT CLEANER CONTROL RELAY AND BATTERY) |
![]() |
Disconnect the A30 headlight cleaner motor and pump connector.
Disconnect the A32 headlight cleaner control relay connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A30-1 - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A30-2 - A32-6 (PB) | Always | Below 1 Ω |
| A30-2 or A32-6 (PB) - Body ground | Always | 10 kΩ or higher |
Reconnect the headlight cleaner motor and pump connector.
Reconnect the headlight cleaner control relay connector.
|
| ||||
| OK | ||
| ||