Home › Engine / Hybrid System · 3UR-FBE › ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR



A184884E01

  1. Partially immerse the sensor in water and warm up the water.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Approx. 20°C (68°F)
    2.32 k to 2.59 kΩ
    1 - 2
    Approx. 80°C (176°F)
    0.310 k to 0.326 kΩ

    If the result is not as specified, replace the sensor.

    NOTICE:
    When checking the sensor in water, keep the terminals dry. After the check, wipe the sensor dry.

    HINT:
    If the result is as specified, do not replace the engine coolant temperature sensor.