Home › Engine / Hybrid System ยท 1UR-FE › COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT
(Click here)


2. REMOVE INLET RADIATOR HOSE


    A215577
  1. Remove the radiator hose.



3. REMOVE FAN SHROUD


    A217580
  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the fan generator V-belt (Click here).

  1. Disconnect the reservoir hose from the upper radiator tank.



    A151821
  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the fluid coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the fan bracket.



4. REMOVE FRONT FENDER APRON SEAL LH
  1. Remove the 6 clips and fender apron seal.



5. DISCONNECT COOLER COMPRESSOR ASSEMBLY (w/ Oil Cooler)


    I104396
  1. Disconnect the connector.

  1. Remove the 2 bolts and 2 nuts.

  1. Remove the 2 stud bolts and cooler compressor.



6. REMOVE WATER BY-PASS PIPE (w/ Oil Cooler)


A210013
  1. Remove the 2 bolts.

  1. Disconnect the 4 water hoses and remove the water by-pass pipe.



7. REMOVE NO. 1 WATER BY-PASS HOSE


    A215865
  1. Remove the water by-pass hose.



8. DISCONNECT NO. 8 WATER BY-PASS HOSE


    A215867
  1. Disconnect the water by-pass hose.



9. DISCONNECT NO. 5 WATER BY-PASS HOSE


    A215869
  1. Disconnect the water by-pass hose.



10. REMOVE WATER INLET HOUSING


    A215871
  1. Remove the 3 bolts and water inlet housing.

  1. Remove the gasket from the water pump.



11. REMOVE WATER PUMP PULLEY


    A210018E02
  1. Using SST, hold the water pump pulley.

    SST
    09960-10010   (09962-01000, 09963-01000)

  1. Remove the 4 bolts and the water pump pulley.



12. REMOVE ENGINE WATER PUMP ASSEMBLY


    A215872
  1. Remove the 8 bolts, engine water pump and the gasket.