DTC B1206 P/W Master Switch Communication Stop |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1206 | No communication between the master switch and main body ECU for 10 seconds or more. |
|

| 1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - MASTER SWITCH) |
![]() |
Disconnect the H2 main body ECU connector.
Disconnect the M2 power window regulator master switch assembly connector.
Measure the resistance and voltage according to the value(s) in the tables below.
| Tester Connection | Condition | Specified Condition |
| H2-10 (LIN2) - M2-6 (LIN1) | Always | Below 1 Ω |
| H2-10 (LIN2) or M2-6 (LIN1) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| M2-6 (LIN1) - Body ground | Always | Below 1 V |
Reconnect the main body ECU connector.
Reconnect the power window regulator master switch assembly connector.
|
| ||||
| OK | |
| 2.CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (MASTER SWITCH - BATTERY AND BODY GROUND) |
![]() |
Disconnect the M2 power window regulator master switch assembly connector.
Measure the resistance and voltage according to the value(s) in the tables below.
| Tester Connection | Condition | Specified Condition |
| M2-1 (E) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| M2-3 (B) - Body ground | Always | 11 to 14 V |
Reconnect the power window regulator master switch assembly connector.
|
| ||||
| OK | |
| 3.REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY |
Temporarily replace the power window regulator master switch assembly with a new or normally functioning one (Click here).
Clear the DTC (Click here).
| NEXT | |
| 4.CHECK FOR DTC |
Recheck for DTCs (Click here).
| Result | Proceed to |
| DTC B1206 is not output | A |
| DTC B1206 is output | B |
|
| ||||
| A | ||
| ||