AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Multi-media Interface ECU |

| 1.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - RADIO RECEIVER) |
![]() |
Disconnect the H110 multi-media interface ECU connector.
Disconnect the I8 radio receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H110-2 (URO+) - I8-2 (CDR+) | Always | Below 1 Ω |
| H110-3 (URO-) - I8-3 (CDR-) | Always | Below 1 Ω |
| H110-4 (ULO+) - I8-4 (CDL+) | Always | Below 1 Ω |
| H110-5 (ULO-) - I8-5 (CDL-) | Always | Below 1 Ω |
| H110-1 (USD1) - Body ground | Always | 10 kΩ or higher |
| H110-2 (URO+) - Body ground | Always | 10 kΩ or higher |
| H110-3 (URO-) - Body ground | Always | 10 kΩ or higher |
| H110-4 (ULO+) - Body ground | Always | 10 kΩ or higher |
| H110-5 (ULO-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||