Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Mute Signal Circuit between Radio Receiver and Multi-media Interface ECU

for Preparation Click here


DESCRIPTION

The multi-media interface ECU sends a mute signal to the radio receiver.
The radio receiver assembly controls the volume according to the MUTE signal from the multi-media interface ECU.
The MUTE signal is sent to reduce noise and popping sounds generated when switching modes.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the radio receiver assembly is functioning, no sound, or only an extremely faint sound, can be heard.

WIRING DIAGRAM


E175068E09


INSPECTION PROCEDURE

1.CHECK MULTI-MEDIA INTERFACE ECU


    E152226E17
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    H110-6 (MUT1) - Body ground
    Ignition switch ACC
    Above 3.5 V



NG
Go to step 2
OK

REPLACE MULTI-MEDIA INTERFACE ECU (Click here)  

2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - MULTI-MEDIA INTERFACE ECU)


    E190393E02
  1. Disconnect the I8 radio receiver assembly connector.

  1. Disconnect the H110 multi-media interface ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I8-6 (MUTE) - H110-6 (MUT1)
    Always
    Below 1 Ω
    I8-6 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE RADIO RECEIVER ASSEMBLY (Click here)