Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    B1441/41    Air Mix Damper Control Servo Motor Circuit (Passenger Side)

for Preparation Click here


DESCRIPTION

The air mix damper servo (for passenger side) sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the air mix damper servo (for passenger side) to any position. As a result, the amount of air that has passed through the evaporator and is now passing through the heater core is adjusted, and the temperature of the air blowing toward the passenger side is controlled.

DTC Code
DTC Detection Condition
Trouble Area
B1441/41
Air mix damper position sensor value does not change even if air conditioning amplifier operates air mix servo motor
  1. Air mix damper servo (for passenger side)
  2. Air conditioning harness
  3. Air conditioning amplifier

WIRING DIAGRAM


E156865E22


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (AIR MIX SERVO TARG PULSE (P))
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Air Conditioner / Data List / Air Mix Servo Targ Pulse (P).

  1. According to the display on the Techstream, read the Data List.

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Air Mix Servo Targ Pulse (P)
    Passenger side air mix servo motor target pulse /
    Min.: 0
    Max.: 255
    MAX. COLD: 105 (pulse)
    MAX. HOT: 6 (pulse)
    -

    OK:
    The display is as specified in the normal condition.


    Result 
    Result
    Proceed to
    NG
    A
    OK (When troubleshooting according to Problem Symptoms Table)
    B
    OK (When troubleshooting according to the DTC output)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
A


2.REPLACE AIR MIX DAMPER SERVO (for Passenger Side)
  1. Temporarily replace the air mix damper servo (for passenger side) with a new one (Click here).

    HINT:
    Since the damper servo cannot be inspected while it is removed from the vehicle, replace the damper servo with a new one and check that the condition returns to normal.


NEXT


3.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTC (Click here).

    OK:
    DTC is not output.



NG
Go to step 4
OK

END (AIR MIX DAMPER SERVO IS DEFECTIVE) 

4.REPAIR OR REPLACE AIR CONDITIONING HARNESS
  1. Repair or replace the air conditioning harness (Click here).


NEXT


5.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTC again (Click here).

    OK:
    DTC is not output.



NG
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
OK

END