Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    B1443/43    Air Outlet Damper Control Servo Motor Circuit

for Preparation Click here


DESCRIPTION

The mode damper servo sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the air outlet damper to any position, which controls the air outlet switching.

HINT:
Confirm that no mechanical problem is present because this diagnostic trouble code can be output when either a damper link or damper is mechanically locked.


DTC Code
DTC Detection Condition
Trouble Area
B1443/43
Air outlet damper position sensor value does not change even if air conditioning amplifier operates air outlet servo motor
  1. Cooling unit damper servo sub-assembly (Air outlet damper servo)
  2. Air conditioning harness
  3. Air conditioning amplifier

WIRING DIAGRAM


E156865E24


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (AIR OUTLET SERVO MOTOR TARGET PULSE)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Air Conditioner / Data List / Air Outlet Servo Pulse (D).

  1. According to the display on the Techstream, read the Data List.

    Air Conditioner 
    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    Air Outlet Servo Pulse (D)
    Air outlet servo motor target pulse /
    Min.: 0
    Max.: 255
    Customized value will be displayed
    -

    OK:
    The display is as specified in the normal condition.


    Result 
    Result
    Proceed to
    NG
    A
    OK (When troubleshooting according to Problem Symptoms Table)
    B
    OK (When troubleshooting according to the DTC output)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
A


2.REPLACE COOLING UNIT DAMPER SERVO SUB-ASSEMBLY (AIR OUTLET DAMPER SERVO)
  1. Temporarily replace the cooling unit damper servo sub-assembly with a new one (Click here).

    HINT:
    Since the damper servo cannot be inspected while it is removed from the vehicle, replace the damper servo with a new one and check that the condition returns to normal.


NEXT


3.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTC (Click here).

    OK:
    DTC is not output.



NG
Go to step 4
OK

END (AIR OUTLET DAMPER SERVO IS DEFECTIVE) 

4.REPAIR OR REPLACE AIR CONDITIONING HARNESS
  1. Repair or replace the air conditioning harness (Click here).


NEXT


5.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTC again (Click here).

    OK:
    DTC is not output.



NG
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
OK

END