DTC B1446/46 Air Mix Damper Control Servo Motor Circuit (Driver Side) |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1446/46 | Air mix damper position sensor value does not change even if air conditioning amplifier operates air mix servo motor |
|

| 1.READ VALUE USING TECHSTREAM (AIR MIX SERVO TARG PULSE (D)) |
Connect the Techstream to DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Air Conditioner / Data List / Air Mix Servo Targ Pulse (D).
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Air Mix Servo Targ Pulse (D) | Driver side air mix servo motor target pulse / Min.: 0 Max.: 255 | Customized value will be displayed | - |
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| OK (When troubleshooting according to the DTC output) | C |
|
| ||||
|
| ||||
| A | |
| 2.REPLACE COOLING UNIT DAMPER SERVO SUB-ASSEMBLY (AIR MIX DAMPER SERVO (for Driver Side)) |
Temporarily replace the cooling unit damper servo sub-assembly (air mix damper servo) with a new one (Click here).
| NEXT | |
| 3.CHECK FOR DTC |
Clear the DTC (Click here).
Check for DTC (Click here).
|
| ||||
| OK | ||
| ||
| 4.REPAIR OR REPLACE AIR CONDITIONING HARNESS |
Repair or replace the air conditioning harness (Click here ).
| NEXT | |
| 5.CHECK FOR DTC |
Clear the DTC (Click here).
Check for DTC again (Click here).
|
| ||||
| OK | ||
| ||