Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR

AUTOMATIC LIGHT CONTROL SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR


    E146012E08
  1. Check the power source circuit and ground circuit.

    1. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Switch Condition
      Specified Condition
      I21-6 (CLTB) - I21-3 (CLTE)
      Ignition switch ON
      11 to 14 V

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      I21-3 (CLTE) - Body ground
      Always
      Below 1 Ω



  1. Check the waveform.



      E163473E01
    1. Check the waveform according to the value(s) in the table below.

      Standard Waveform:
      Tester Connection
      Tool Setting
      Switch Condition
      Specified Condition
      I21-3 (CLTE) - I21-5 (CLTS)
      5 V/DIV., 5 msec./ DIV.
      Ignition switch ON, Headlight dimmer switch AUTO
      Correct waveform is as shown

      HINT:
      If the ambient light becomes brighter, width A becomes narrower.
      If the result is not as specified, replace the automatic light control sensor.