Home › Vehicle Interior › SEAT › LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Manual Seat)

LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Manual Seat) > INSTALLATION

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY LH


    B190994
  1. Engage the 3 claws and install the bush.



    B190990
  1. Install the lumbar support adjuster assembly with the 2 screws.

  1. Connect the lumbar support adjuster connector.



    B190989E03
  1. Engage the 6 hooks to install the seatback springs.

  1. Install the 2 springs.



2. INSTALL SEATBACK COVER WITH PAD


    B194821E02
  1. Install the seatback cover with pad to the seatback frame.

  1. Lift the seatback cover and, using hog ring pliers, install 4 new hog rings to the seat frame.

  1. Lift the seatback cover, connect the seatback cover bracket to the seat frame, and install the nut.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    CAUTION:
    After the seatback trim cover is assembled, make sure that the side airbag strap is not twisted.



3. INSTALL FRONT SEAT HEADREST SUPPORT


    B191062E02
  1. Align the protruding portion of the front seat headrest support with the installation groove of the front seatback frame.

  1. Engage the 4 claws to install the 2 headrest supports.



    B194822E01
  1. Install the seatback cover wires.

  1. Using hog ring pliers, install 2 new hog rings to the seat frame.



    B190983
  1. Engage the hook.



    B194823E01
  1. Using hog ring pliers, install 3 new hog rings to the seat frame.



4. INSTALL FRONT SEAT HEADREST ASSEMBLY


5. INSTALL FRONT SEAT CUSHION SHIELD INNER LH


    B191000E01
  1. Install the harness to the front seat cushion shield.

  1. Engage the 3 claws in the order shown in the illustration, and install the cushion shield.

  1. Install the screw.



6. INSTALL FRONT SEAT CUSHION SHIELD LH


    B191001E01
  1. Connect the connector and install the harness to the front seat cushion shield.

  1. Engage the 3 claws in the order shown in the illustration, and install the front seat cushion shield.

  1. Install the 3 screws.



    B191002E01
  1. Using hog ring pliers, install the rubber band of the seatback cover to the seat frame with 2 new hog rings.



7. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH


    B194817
  1. Engage the claw to install the reclining adjuster release handle.



8. INSTALL VERTICAL SEAT ADJUSTER KNOB LH (for 8 Way Seat)


    B191003
  1. Install the snap ring to the vertical seat adjuster knob.

  1. Install the vertical seat adjuster knob to the front seat.



9. INSTALL VERTICAL ADJUSTING HANDLE LH


    B190970
  1. Install the vertical adjusting handle with the 2 screws.



10. INSTALL VERTICAL SEAT ADJUSTER KNOB CAP


    B200259
  1. Engage the 2 claws to install the vertical adjuster handle cap.



11. INSTALL FRONT SEAT ASSEMBLY LH
  1. Install the front seat (Click here).