LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Manual Seat) > REMOVAL |
| 1. REMOVE FRONT SEAT ASSEMBLY LH |
Remove the front seat (Click here).
| 2. REMOVE VERTICAL SEAT ADJUSTER KNOB CAP |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the vertical adjuster handle cap.
| 3. REMOVE VERTICAL ADJUSTING HANDLE LH |
![]() |
Remove the 2 screws and vertical adjusting handle.
| 4. REMOVE VERTICAL SEAT ADJUSTER KNOB LH |
![]() |
Using a screwdriver with its tip wrapped in protective tape, remove the snap ring and vertical seat adjuster knob.
| 5. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH |
![]() |
Lift the reclining adjuster release handle.
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the reclining adjuster release handle.
| 6. REMOVE FRONT SEAT CUSHION SHIELD LH |
![]() |
Remove the 2 hog rings and rubber bands of the seatback cover from the seat frame.
![]() |
Remove the 3 screws.
Disengage the 3 claws in the order shown in the illustration, and then separate the front seat cushion shield.
Separate the harness from the front seat cushion shield, disconnect the connector, and remove the front seat cushion shield.
| 7. REMOVE FRONT SEAT CUSHION SHIELD INNER LH |
![]() |
Remove the screw.
Disengage the 3 claws in the order shown in the illustration, and then separate the front seat cushion shield.
Separate the harness form the front seat cushion shield and remove the front seat cushion shield.
| 8. REMOVE FRONT SEAT HEADREST ASSEMBLY |
| 9. REMOVE FRONT SEAT HEADREST SUPPORT |
![]() |
Remove the 3 hog rings.
![]() |
Disengage the hooks.
![]() |
Remove the 2 hog rings and seatback cover wires.
![]() |
Disengage the 4 claws and remove the 2 front seat headrest supports.
| 10. REMOVE SEATBACK COVER WITH PAD |
![]() |
Lift the seatback cover and remove the nut and seatback cover bracket from the seat frame.
Lift the seatback cover and remove the 4 hog rings and seatback cover with pad.
| 11. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH |
![]() |
Remove the 2 springs.
Disengage 6 hooks and remove the seatback spring.
![]() |
Disconnect the lumbar support adjuster connector.
Remove the 2 screws and lumbar support adjuster assembly.
![]() |
Disengage 3 claws and remove the bush from the seat frame.