Home › Vehicle Interior › SEAT › SEAT HEATER SWITCH (for Rear No. 1 Seat)

SEAT HEATER SWITCH (for Rear No. 1 Seat) > INSPECTION

for Preparation Click here



1. INSPECT SEAT HEATER SWITCH LH


B194045E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      5 (HI) - 4 (E)
      Switch ON (HI)
      Below 1 Ω
      5 (HI) - 4 (E)
      Switch OFF
      10 kΩ higher
      3 (LO) - 4 (E)
      Switch ON (LO)
      Below 1 Ω
      3 (LO) - 4 (E)
      Switch OFF
      10 kΩ higher

      If the result is not as specified, replace the switch.

  1. Check the illumination operation.

    1. Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.

      OK:
      Measurement Condition
      Switch Condition
      Specified Condition
      Battery positive (+) → 6 (ILL+)
      Battery negative (-) → 4 (E)
      Always
      Illuminates

      If the result is not as specified, replace the switch.

  1. Check the indicator operation.

    1. Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.

      OK:
      Measurement Condition
      Switch Condition
      Specified Condition
      Battery positive (+) → 7 (IG)
      Battery negative (-) → 8 (HI IND)
      Switch ON (HI)
      Illuminates
      Battery positive (+) → 7 (IG)
      Battery negative (-) → 2 (LO IND)
      Switch ON (LO)
      Illuminates

      If the result is not as specified, replace the switch.



2. INSPECT SEAT HEATER SWITCH RH


B195230E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      5 (HI) - 4 (E)
      Switch ON (HI)
      Below 1 Ω
      5 (HI) - 4 (E)
      Switch OFF
      10 kΩ higher
      3 (LO) - 4 (E)
      Switch ON (LO)
      Below 1 Ω
      3 (LO) - 4 (E)
      Switch OFF
      10 kΩ higher

      If the result is not as specified, replace the switch.

  1. Check the illumination operation.

    1. Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.

      OK:
      Measurement Condition
      Switch Condition
      Specified Condition
      Battery positive (+) → 6 (ILL+)
      Battery negative (-) → 4 (E)
      Always
      Illuminates

      If the result is not as specified, replace the switch.

  1. Check the indicator operation.

    1. Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.

      OK:
      Measurement Condition
      Switch Condition
      Specified Condition
      Battery positive (+) → 7 (IG)
      Battery negative (-) → 8 (HI IND)
      Switch ON (HI)
      Illuminates
      Battery positive (+) → 7 (IG)
      Battery negative (-) → 2 (LO IND)
      Switch ON (LO)
      Illuminates

      If the result is not as specified, replace the switch.