Home › Vehicle Interior › SEAT › FRONT SEAT CUSHION HEATER

FRONT SEAT CUSHION HEATER > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat (Click here).



2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB LH


    B201567E01
  1. Apply protective tape around the cushion shield.

  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE RECLINING POWER SEAT SWITCH KNOB LH


    B201568E01
  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT SEAT CUSHION SHIELD LH


    B191013
  1. Remove the hog rings and rubber bands of the seatback cover from the seat frame.

  1. Remove the 2 screws.



    B166945
  1. Remove the 3 screws.

  1. Detach the 2 claws and remove the cushion shield.

  1. Disconnect the connectors.



5. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH


    B191249
  1. Disconnect the connector and disengage the 5 clamps.



    B191255
  1. Remove the nut and front seat inner belt LH.



6. REMOVE FRONT SEAT CUSHION SHIELD INNER LH


    B191015
  1. Remove the screw.

  1. Detach the 2 claws and clip, and remove the cushion shield.



7. REMOVE FRONT POWER SEAT SWITCH LH


    B166949
  1. Disconnect the connectors.

  1. Remove the 3 screws and switch.



8. REMOVE SEAT CUSHION COVER WITH PAD (w/ Leg Support Adjustment Switch)


    B167097
  1. Using a clip remover, remove the 2 clips.



    B191016E01
  1. Disconnect the connector and detach the 2 wire harness clamps.



    B191017
  1. Disconnect the connector and detach the 2 wire harness clamps.



    B191018
  1. Remove the 4 hog rings and detach the hooks.



    B167096
  1. Remove the seat cushion cover wire.

  1. Remove the seat cushion cover with pad from the seat frame.



9. REMOVE SEAT CUSHION COVER WITH PAD (w/o Leg Support Adjustment Switch)


    B167097
  1. Using a clip remover, remove the 2 clips.



    B194825E01
  1. Disconnect the connector and detach the 2 wire harness clamps.



    B194826
  1. Disconnect the connector and detach the 2 wire harness clamps.



    B191019
  1. Remove the 2 hog rings.

  1. Bend the 2 seat frame claws upward.

  1. Detach the hooks and remove the seat cushion cover with pad.



10. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER (w/ Leg Support Adjustment Switch)


  1. Remove the 15 hog rings and front seat cushion cover.


    B191020



11. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER (w/o Leg Support Adjustment Switch)


    B191021
  1. Remove the 10 hog rings and front seat cushion cover.



12. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH


    B194831
  1. Cut off the 30 tack pins which fasten the seat heater to the seat cushion cover, and then remove the seat cushion heater from the seat cushion cover.