Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT COIL SPRING


C159782E01
  1. Using SST, compress the coil spring.

    SST
    09727-30021  

    NOTICE:
    1. Do not compress the coil spring more than necessary.
    2. Do not use an impact wrench. It will damage SST.



    C155966E03
  1. Install the coil spring to the shock absorber.
    Text in Illustration 
    *a
    Lower End

    HINT:
    Fit the lower end of the coil spring into the recess of the spring seat of the shock absorber.



2. INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY (w/o Air Suspension)
  1. Install the 2 cushions, 2 retainers and suspension support to the piston rod.

  1. Temporarily install a new suspension support to front shock absorber nut.



  1. Position the suspension support as shown in the illustration.


    C155967E02


    Text in Illustration 
    *1
    Suspension Support Bolt
    -
    -
    *a
    LH Side
    *b
    RH Side
    *c
    Absorber Bush Axis
    *d
    Coil Spring Lower End
    *e
    20 mm (0.787 in.)
    -
    -

  1. Remove SST.

    NOTICE:
    Do not use an impact wrench. It will damage the shock absorber rod.

    HINT:
    Release the coil spring while checking the position of the suspension support.



3. INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY (w/ Air Suspension)
  1. Install the 2 cushions, 2 retainers, collar and suspension support to the piston rod.

  1. Temporarily install a new suspension support to front shock absorber nut.



  1. Position the suspension support as shown in the illustration.


    C155967E02


    Text in Illustration 
    *1
    Suspension Support Bolt
    -
    -
    *a
    LH Side
    *b
    RH Side
    *c
    Absorber Bush Axis
    *d
    Coil Spring Lower End
    *e
    20 mm (0.787 in.)
    -
    -

  1. Remove SST.

    NOTICE:
    Do not use an impact wrench. It will damage the shock absorber rod.

    HINT:
    Release the coil spring while checking the position of the suspension support.



4. TIGHTEN FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT
  1. Tighten the nut.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }