METER / GAUGE SYSTEM > OPERATION CHECK |
| INSPECT INDICATOR/WARNING LIGHT |
Check the following indicators and warning lights.
| Warning/Indicator Light | Switch Condition | Specified Condition |
| Height control HI indicator light*1 | Ignition switch off → ON | Comes on for 2 seconds |
| Height control N indicator light*1 | Ignition switch off → ON | Comes on for 2 seconds |
| Height control LO indicator light*1 | Ignition switch off → ON | Comes on for 2 seconds |
| Height control MAN. indicator light*1 | Ignition switch off → ON | Comes on for 2 seconds |
| Brake warning light | Ignition switch off → ON | Comes on for 3 seconds |
| ABS warning light | Ignition switch off → ON | Comes on for 3 seconds |
| SLIP indicator light | Ignition switch off → ON | Comes on for 3 seconds |
| AUTO LSD indicator light | Ignition switch off → ON | Comes on for 3 seconds |
| VSC OFF indicator light | Ignition switch off → ON | Comes on for 3 seconds |
| RSCA OFF indicator light | Ignition switch off → ON | Comes on for 3 seconds |
| TOW HAUL indicator light*2 | Ignition switch off → ON | Comes on for 3 seconds |
| EPS warning light | Ignition switch off → ON | Comes on for 3 seconds |
| Tire pressure warning light | Ignition switch off → ON | Comes on for 3 seconds |
| MAIN REQD indicator light*3 | Ignition switch off → ON | Comes on for 3 seconds |
| SRS warning light | Ignition switch off → ON | Comes on for 6 seconds |
| A/T OIL TEMP warning light | Ignition switch off → ON | Illuminates when ignition switch is turned to ON. Turns off when engine is started. |
| CHARGE warning light | Ignition switch off → ON | Illuminates when ignition switch is turned to ON. Turns off when engine is started. |
| MIL | Ignition switch off → ON | Illuminates when ignition switch is turned to ON. Turns off when engine is started. |
| INSPECT SPEEDOMETER |
Connect the Techstream to the DLC3 connector.
Turn the ignition switch ON.
Turn the Techstream ON.
Enter the following menus: Powertrain / Engine and ECT / Data List.
According to the display on Techstream, read the Data List.
| Techstream Display | Speedometer Display |
| 20 mph | 19 to 22 mph |
| 40 mph | 39 to 42.5 mph |
| 60 mph | 59.5 to 63.5 mph |
| 80 mph | 79.5 to 84 mph |
| 100 mph | 100 to 105 mph |
| Techstream Display | Speedometer Display Data in ( ) is for reference |
| 20 km/h | (17.5 to 21.5 km/h) |
| 40 km/h | 38 to 42 km/h |
| 60 km/h | 58 to 63 km/h |
| 80 km/h | 78 to 84 km/h |
| 100 km/h | 98.5 to 104.5 km/h |
| 120 km/h | 119 to 125 km/h |
| 140 km/h | 139 to 146 km/h |
| 160 km/h | 159 to 167 km/h |
| 180 km/h | 179 to 188 km/h |
Check the deflection width of the speedometer indicator.
| INSPECT TACHOMETER |
Connect a tune-up tachometer, and start the engine.
Compare the test results with the tachometer indicator.
| Standard indication (rpm) | Acceptable range Data in ( ) is for reference |
| 700 | 630 to 770 |
| 1000 | (900 to 1100) |
| 2000 | (1850 to 2150) |
| 3000 | 2800 to 3200 |
| 4000 | (3800 to 4200) |
| 5000 | 4800 to 5200 |
| 6000 | (5750 to 6250) |
| INSPECT METER/GAUGE |
Connect the Techstream to the DLC3.
Perform Active Test (Click here).
| INSPECT WARNING/INDICATOR LIGHT |
Connect the Techstream to the DLC3.
Perform Active Test (Click here).
| INSPECT MULTI-INFORMATION DISPLAY (w/ Multi-information Display) |
Connect the Techstream to the DLC3.
Perform Active Test (Click here).