Home › Engine / Hybrid System ยท 3UR-FBE › FUEL › FUEL SENDER GAUGE ASSEMBLY

FUEL SENDER GAUGE ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
  1. Remove the fuel suction with pump and gauge tube assembly (Click here).



2. REMOVE FUEL SENDER GAUGE ASSEMBLY


    A194625E01
  1. Disconnect the connector from the fuel suction plate.



    A194626
  1. Using a screwdriver, remove the cap from the connector.

    HINT:
    Tape the screwdriver tip before use.



    A194627
  1. Detach the 2 claws and remove the cover from the connector.



    A194660E01
  1. As shown in the illustration, unlatch the tabs of the 2 terminals and pull out the 2 wires (blue) from the connector.



    A201437
  1. Detach the 2 claws and disconnect the wire harness.



    A201438E01
  1. Push the tab to release the lock of the fuel sender gauge, and slide the fuel sender gauge to remove it.