Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Turn the ignition switch off.

  2. Connect the Techstream to the DLC3.

  3. Turn the ignition switch to ON.

  4. Turn the Techstream on.

  5. Enter the following menus: Body Electrical / (desired system) / Data List.

  6. According to the display on the Techstream, read the Data List.

    SRS Airbag 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Passenger Classification
    Passenger classification:
    NG: Data is not determined
    OFF: Vacant
    Child: Child (less than 36 kg (79.37 lb)) is seated
    AF05: Adult (36 to 54 kg (79.37 to 119.05 lb) is seated
    AM50: Adult (more than 54 kg (119.05 lb)) is seated
    Fail: A failure is detected
    OFF, Child, AF05 or AM50
    -
    Driver Buckle SW
    Driver seat belt buckle switch
    Unset: Driver seat belt is unfastened
    Set: Driver seat belt is fastened
    NG: Data is not determined
    Unset or Set
    -
    Passenger Buckle SW
    Front passenger seat belt buckle switch:
    Unset: Front passenger seat belt is unfastened
    Set: Front passenger seat belt is fastened
    NG: Data is not determined
    Unset or Set
    -

    Occupant Detection 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Passenger Buckle SW
    Front passenger seat belt buckle switch:
    Unset: Front passenger seat belt is unfastened
    Set: Front passenger seat belt is fastened
    NG: Data is not determined
    Unset or Set
    -
    Passenger Classification
    Passenger classification:
    NG: Data is not determined
    OFF: Vacant
    Child: Child (less than 36 kg (79.37 lb)) is seated
    AF05: Adult (36 to 54 kg (79.37 to 119.05 lb) is seated
    AM50: Adult (more than 54 kg (119.05 lb)) is seated
    Fail: A failure is detected
    OFF, Child, AF05 or AM50
    -

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    P-Seatbelt Warning Buzzer
    Front passenger seat belt warning buzzer:
    ON: Front passenger seat belt warning buzzer ON setting
    OFF: Front passenger seat belt warning buzzer OFF setting
    ON or OFF
    -


PERFORM ACTIVE TEST

HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Turn the ignition switch off.

  2. Connect the Techstream to the DLC3.

  3. Turn the ignition switch to ON.

  4. Turn the Techstream on.

  5. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  6. According to the display on the Techstream, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Driver Side Seat Belt
    Driver side seat belt warning light
    Driver side seat belt warning light is ON or OFF
    Confirm that the vehicle is stopped, engine idling
    Front Passenger Side Seat Belt
    Front passenger side seat belt warning light
    Front passenger side seat belt warning light is ON or OFF
    Confirm that the vehicle is stopped, engine idling