LIGHTING SYSTEM > Hazard Warning Switch Circuit |

| 1.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY |
![]() |
Remove the hazard warning signal switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 (E) - 4 (B1) | Hazard warning switch ON | Below 1 Ω |
| Hazard warning switch OFF | 10 kΩ or higher |
Reinstall the hazard warning switch assembly.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH - TURN SIGNAL FLASHER) |
![]() |
Disconnect the J3 hazard warning signal switch assembly connector.
Disconnect the H39 turn signal flasher assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J3-4 (B1) - H39-12 (HAZ) | Always | Below 1 Ω |
| J3-1 (E) - Body ground | Always | Below 1 Ω |
| J3-4 (B1) - Body ground | Always | 10 kΩ or higher |
reconnect the turn signal flasher assembly connector.
Reconnect the hazard warning signal switch assembly connector.
|
| ||||
| OK | ||
| ||