Home › Vehicle Exterior › DOOR / HATCH › HOOD SUPPORT

HOOD SUPPORT > DISPOSAL

for Preparation Click here



1. DISPOSE OF HOOD SUPPORT ASSEMBLY


    B166020E02
  1. Secure the hood support assembly horizontally in a vise with the piston-rod pulled out.

  1. Wear safety glasses. Use a metal saw to slowly cut a groove between A and B shown in the illustration to release the gas.

    NOTICE:
    Although the gas inside the back door stay assembly is colorless, odorless, and harmless, metal debris may scatter. Therefore, cover the back door stay assembly with a piece of cloth or other material.