Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)

STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column) > REASSEMBLY

for Preparation Click here



1. INSTALL IGNITION SWITCH ASSEMBLY


C155157
  1. Attach the 2 claws to install the ignition switch to the switch bracket.



2. INSTALL KEY INTERLOCK SOLENOID


C155158
  1. Install the key interlock solenoid to the switch bracket with the 2 screws.



3. INSTALL UNLOCK WARNING SWITCH ASSEMBLY


C155156
  1. Attach the 2 claws to install the unlock warning switch to the switch bracket.



4. INSTALL IGNITION SWITCH LOCK CYLINDER
  1. Check that the ignition switch lock cylinder is in the ACC position.



    C103932E02
  1. Install the ignition switch lock assembly to the switch bracket.

  1. Check that the ignition switch lock cylinder is securely installed.



5. INSPECT STEERING LOCK OPERATION


6. INSTALL UPPER STEERING COLUMN CLAMP WITH SWITCH BRACKET ASSEMBLY
  1. Temporarily install the steering column upper with switch bracket and the steering lock bracket with 2 new tapered-head bolts.



    C159756
  1. Tighten the 2 tapered-head bolts until the bolt heads break off.



7. INSTALL TRANSPONDER KEY AMPLIFIER
  1. Align the transponder key amplifier with the installation position of the upper bracket with the amplifier inclined.



    C155160
  1. Push the transponder key amplifier upward and install it to the switch bracket.

    NOTICE:
    Do not push the amplifier up with excessive force.



8. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU


C159704
  1. Install the ECU with the 2 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }

  1. Connect the 2 ECU connectors.