DTC B1445/45 Passenger Side Cool Air Bypass Damper Control |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1445/45 | Cool air bypass servo motor position sensor value does not change even if air conditioning amplifier operates cool air bypass servo motor |
|

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (COOL AIR BYPASS PULSE) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Air Conditioner / Active Test / Cool Air Bypass Pulse.
While performing the Active Test, confirm that the air blown from the front center and front side registers changes in temperature.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Cool Air Bypass Pulse | Cool air bypass servo motor | Min.: 0 Max.: 255 | - |
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| OK (When troubleshooting according to the DTC output) | C |
|
| ||||
|
| ||||
| A | |
| 2.REPLACE COOL AIR BYPASS DAMPER SERVO (for Passenger Side) |
Temporarily replace the cool air bypass damper servo with a new one (Click here).
| NEXT | |
| 3.CHECK FOR DTC |
Clear the DTC (Click here).
Check for DTC (Click here).
|
| ||||
| OK | ||
| ||
| 4.REPAIR OR REPLACE AIR CONDITIONING HARNESS |
Repair or replace the air conditioning harness (Click here).
| NEXT | |
| 5.CHECK FOR DTC |
Clear the DTC (Click here).
Check for DTC again (Click here).
|
| ||||
| OK | ||
| ||