Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER

NAVIGATION RECEIVER > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



2. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



3. REMOVE INSTRUMENT SIDE PANEL LH


    B226739
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B229064
  1. Remove the 2 bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B161741
  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


B161742
  1. Detach the 12 clips and remove the console panel.



7. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


B222976
  1. Move the shift lever to N.

  1. Remove the clip.

  1. Detach the 6 clips and remove the console panel.

  1. Disconnect the connector



8. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


B192334
  1. Detach the 4 claws and remove the instrument panel finish panel retainer.



    B192335
  1. Disconnect the 2 connectors and detach the wire harness clamp.

  1. Detach the 12 clips and remove the finish panel.



9. REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL


    B192336
  1. Detach the 4 clips and 2 claws.

  1. Disconnect the connectors and remove the finish panel.



10. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


I104352
  1. Detach the 4 clips and separate the panel.

  1. Disconnect the connectors and remove the panel.



11. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for DVD)


B164792
  1. Remove the 4 bolts.



    E159005
  1. Pull the navigation receiver as shown in the illustration to disengage the 3 clips on the backside of the navigation receiver.

  1. Disconnect the connectors and remove the navigation receiver.



12. REMOVE NO. 1 RADIO BRACKET (for DVD)


B164795
  1. Remove the 4 bolts and bracket.



13. REMOVE NO. 2 RADIO BRACKET (for DVD)


B164794
  1. Remove the 4 bolts and bracket.



14. REMOVE NAVIGATION RECEIVER ASSEMBLY (for SD)


    E232001
  1. Remove the 4 bolts.



    E232002
  1. Pull the navigation receiver as shown in the illustration to disengage the 2 clips on the backside of the navigation receiver.

  1. Disconnect the connectors and remove the navigation receiver.



15. REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL (for SD)


    B229213
  1. Remove the 4 screws and upper instrument cluster finish panel.



16. REMOVE NO. 1 RADIO BRACKET (for SD)


    E232003
  1. Remove the 4 bolts and bracket.



17. REMOVE NO. 2 RADIO BRACKET (for SD)


    E232004
  1. Remove the 4 bolts and bracket.