Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Clearance Warning Buzzer Circuit

for Preparation Click here


DESCRIPTION

The clearance warning buzzer is installed in the accessory meter.

WIRING DIAGRAM


E146060E02


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-IG No. 1)


    E160643E01
  1. Remove the ECU-IG No. 1 fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG No. 1 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (ACCESSORY METER ASSEMBLY - BATTERY AND BODY GROUND)


    E146329E02
  1. Disconnect the I22 accessory meter assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I22-23 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (ACCESSORY METER ASSEMBLY - CLEARANCE WARNING ECU)


    E146059E03
  1. Disconnect the H43 clearance warning ECU connector.

  1. Disconnect the I22 accessory meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H43-12 (BBZ) - I22-11 (BZ)
    Always
    Below 1 Ω
    H43-12 (BBZ) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE ACCESSORY METER ASSEMBLY
  1. Replace the accessory meter assembly with a normally functioning or new accessory meter assembly (Click here).

  1. Check that the accessory meter buzzer operates normally.

    OK:
    Accessory meter buzzer operates normally.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (ACCESSORY METER IS DEFECTIVE)