NAVIGATION SYSTEM (for SD) > Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the I28 navigation receiver assembly connector.
Disconnect the I51 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I28-17 (ALI) - I51-6 | Always | Below 1 Ω |
| I28-15 (ARI) - I51-5 | Always | Below 1 Ω |
| I28-16 (ASGN) - I51-7 | Always | Below 1 Ω |
| I28-18 (AUXG) - I51-9 | Always | Below 1 Ω |
| I28-19 (AUXI) - I51-8 | Always | Below 1 Ω |
| I28-17 (ALI) - Body ground | Always | 10 kΩ or higher |
| I28-15 (ARI) - Body ground | Always | 10 kΩ or higher |
| I28-16 (ASGN) - Body ground | Always | 10 kΩ or higher |
| I28-18 (AUXG) - Body ground | Always | 10 kΩ or higher |
| I28-19 (AUXI) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||